Placement of the tool holder module can be vertical or horizontal and positioned so that the inserted tool can be to the left, front/top or right. This versatility allows many tools to work in the HandWorker.

The HandWorker Inverter Kit inverts the tool holder module. This allows special tools that require the tool head to stay in position and work by moving the upper arm only.

SPECIFICATIONS
HandWorker System (HW-510)
includes tool holder module, actuator unit, mounting base, air filter/pressure regulator with gauge, foot control, air tubing, wrenches and instructions. Extra tool holder modules are also available (HW-515).

• Air Requirements: 120 psi (8 bar) maximum input. For most purposes, adequate air pressure input is 80 to 100 psi (5.5 to 6.8 bar)
• Force on tool: Fully adjustable from zero to maximum using built-in regulator. Tool force in pounds is 2.0 times the regulated air pressure in psi (in kilograms, 13.2 times the regulated air pressure in bar).
• Actuator stroke: From 0 to 2.05" (0 to 52mm). Tool will close fully or can be set to less than full closure with the adjustable stop.
• Tool Size Range: Fits a variety of pliers, cutters, crimpers, strippers, pop riveters, scissors, snips and other pivoted hand tools from about 5" to 12" (125mm to 300mm) long.

PDF INSTRUCTIONS
HANDWORKER
INVERTER
GUARD
FLOW CONTROL